![]() ![]() ![]() OTP area for CDP+ Clone 100251 bin file.ħ. STM32 ST-Link Utility v3.4.0 to read firmware and otp and if you are willing to risk to change them.Ħ. Flash Loader Demonstrator v2.6.0 to restore your firmware via USBĦ. This area can be modified only by incrementing the actual serial number in the already written ST chip or you can write any number in a new one if you know how.ĥ. How to read the OTP (One Time Programming) area responsable for the serial number of your interface - BE CAREFUL. How to read your firmware with a ST-Link device via CDP+ J400 connector and also pinout of STLink to J400Ĥ. How to recover your CDP+ from a bad flash or red lights problem via USB.ģ. Mprog 3.5 and ept file for CDP+ (never seen one that has this problem)Ģ. Story short, what will you find inside this pack:ġ. We (at least me) prefer to write the firmware with WOW because like this i can use wow and delphi-autocom without problems since WOW writes some extra bits that delphi-autocom does not detect but wow does. So i was thinking these days to make a full pack at day regarding the the firmware our CDP+ interfaces.Īs you all know we can flash our interface SAFE only inside Delphi 2012.3 (last version without clone blacklist) or in these days inside WOW (no matter what version). ![]() CDP+ Delphi Autocom Firmware Recovery,OTP Area,Firmwares ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |